Code Alarm Professional Series CA 1050 Instrukcja Użytkownika Pobierz pdf (Strona 10)

15. Cleaning and Servicing the Filter

The lter is a very important component of the machine and essential for correct operation.

Proper lter maintenance will allow you to obtain the best performance from your machine.

The lter can be cleaned in any of the following three ways:

1. By means of the automatic cleaning system

According to the chosen work program, the machine is programmed to automatically clean the lter

at regular preset intervals.

2. By means of an electric lter shaker that is manually started

Just a simple command is needed to keep the lter in perfect working order: press the button marked

‘F’ and hold it down for a few seconds. Repeat this operation 4 or 5 times. Remember that the cleaner

the lter, the better the results of your cleaning session. It is recommended to carry this operation out

at the end of each work cycle.

NOTE: dusty environments

If you are using the machine in a dusty environment (e.g. sawmills– warehouses where haulage

vehicles pass, etc.), it is a good idea to use the lter shaker more frequently.

3. By manually cleaning the lter

If operating the lter shaker is not enough to keep the lter clean- and in any case every 20 hours of

work - clean the lter manually. Before carrying out any kind of intervention on the machine, make

sure it is turned o and that all functions are deactivated. To obtain this condition, turn the switch

marked ‘L’ to OFF.

1. Remove the rear box from the machine

2. Take the lter out of its seat by turning the two xing handles.

3. Blow compressed air onto the side of the lter featuring the protective net (at a pressure of 6

bar at the most).

4. Ret the lters and the rear panel.

16. Fitting and Replacing the Side Brushes

To facilitate transport, the side brush (or brushes) is not tted in its expected working position. To t the brush

in its correct working position, proceed as follows:

1. Pull up the brush knob.

2. Loosen the screw on the shaft of the side brush motor.

3. Remove the key protection.

4. Place the brush with its ange on the shaft.

5. Tighten the xing screw.

To replace worn side brushes, carry out the operations listed above.

Important : raise and lower the side brushes while the machine is running.

17. Replacing Light Bulbs

To replace the front light bulb:

1. Remove the front cover by loosening the xing screws.

2. Replace the bulb, making sure that the new bulb has suitable electrical features.

3. Ret the front cover.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

Code Alarm Professional Series CA 1050 Instrukcja Użytkownika Strona 10